San Jose Navigation GPS Mobile Locator GM-158-USB Dokumentacja Pobierz pdf (Strona 5)

www.malags.com

2 CX Start up

__________________________________________________

Before starting up the MALÅ CX GPR system the following connections

must be made:

- The CX to the antenna, using the antenna cable. The antenna cable

should always be connected before the CX unit is powered on.

- The CX to the battery or other power source, using the battery cable.

See Chapter 11.

- The encoder wheel to the antenna.

When all connections have been made, the CX can be turned on. Pressing

the On/Off button at top right-hand corner activates the system. More

information on the High Frequency Antennas can be found in Chapter 12.

Note! The antennas should be ON for a while before measurement, to

warm-up. An appropriate time is approximately 10 minutes.

Once active, the CX is operated using a dual function turn-push button

(bottom right on the monitor) to control the settings. By turning the button

right or left, a selection from a specific menu can be highlighted. By

pushing the button, the selection is activated.

Power

Antenna cable

Encoder

1 2 3 4 5 6 7 8 9 10 ... 44 45

Brak uwag

San Jose Navigation GPS Mobile Locator GM-158-USB Dokumentacja Strona 5